排序方式: 共有83条查询结果,搜索用时 15 毫秒
51.
52.
高频逆变型静电高压电源的研究 总被引:1,自引:0,他引:1
本文以能量法为基础 ,分析高频逆变型电容倍压的高压电源基本工作原理。采用高频逆变技术及高频变压器特殊设计 ,实现的静电高压电源具有体积小 ,重量轻的优点 相似文献
53.
为使起重机在落货时,通过控制DC/DC变换器,用超级电容回收再生能量,根据起重机的工作特点,在VB 6.5环境下,设计通信和动态数据处理程序,构建采用超级电容及能量管理系统的能量管理实时监控系统.实验装置的试验结果表明,采用能量管理实时监控系统,可以控制超级电容充电时间,提高装卸机械的运行性能. 相似文献
54.
潘秀英 《科技成果管理与研究》2009,(1):87-90
文章重点介绍了电容器高频阻抗的特性以及测量方法,并分析了电容器高频阻抗参数的测量结果的不确定度。 相似文献
55.
祁翔 《贵阳金筑大学学报》2009,(2):10-12
两个带电电容器在连接前后的能量发生变化,论述了换路过程中,在理想和实际两种情况下电容电压是否发生跃,并解释其能量损失原因。 相似文献
56.
A low cost of die area and power consumption CMOS image sensor readout circuit with fixed pattern noise(FPN) cancellation is proposed.By using only one coupling capacitor and switch in the double FPN cancelling correlative double sampling(CDS),pixel FPN is cancelled and column FPN is stored and eliminated by the sampleand-hold operation of digitally programmable gain amplifier(DPGA).The bandwidth balance technology based on operational amplifier(op-amp) sharing is also introduced to decrease the power dissipation of traditional multi-stage switched capacitor DPGA.The circuit is designed and simulated using 1P6M 0.18 μm 1.8 V/3.3 V process.Simulation results indicate that the proposed CDS scheme can achieve an FPN of less than 1 mV.The total sampling capacitor per column is 0.9 pF and no column-wise power is dissipated.The die area and FPN value are cut by 70% and 41% respectively compared with amplifier-based CDS.The op-amp sharing gain stage can achieve a 12-bit precision and also implement an 8-bit gain controlling within a gain range of 24 dB.Its power consumption is 1.4 mW,which is reduced by 57% compared with traditional schemes.The proposed readout circuit is suitable for the application of low power cost-sensitive imaging systems. 相似文献
57.
通过创新思维,将力学、电磁学理论应用于直流电路和感应器,从直流电路中产生出交流电.此研究对于开发具有广阔市场前景的交直流同时供电的发电设备具有重要的理论和实践意义. 相似文献
58.
介绍了一种应用于DRM/DAB频率综合器的宽带低相位噪声低功耗的CMOS压控振荡器.为了获得宽工作频带和大调谐范围,在LC谐振腔里并联一个开关控制的电容阵列.所设计的压控振荡器应用中芯国际的0.18μm RF CMOS工艺进行了流片实现.包括测试驱动电路和焊盘,整个芯片面积为750μm×560μm.测试结果表明,该压控振荡器的调谐范围为44.6%,振荡频率范围为2.27~3.57GHz.其相位噪声在频偏为1MHz时为-122.22dBc/Hz.在1.8V的电源电压下,其核心的功耗为6.16mW. 相似文献
59.
复合薄膜电容器的复合薄膜是一种层状的结构,在本文中采用的是石墨烯与纳米纤维间隔相容,使电容器的机械性能进一步的提高,也增加了它的柔软性,通过实验也进一步证明,复合薄膜电容器的电导率是传统纳米纤维薄膜电容器的10倍左右。 相似文献
60.
设计了一种用于片上系统的无片外电容的CMOS低压差线性稳压器(LDO),其输出电压为3.3 V,最大输出电流为100 mA.该设计可以有效地减少芯片引脚和电路板面积.通过在传统结构上使用动态摆率增强电路和嵌套式米勒补偿技术,LDO在线性和负载响应过程中都有很强的稳定性.当输出电流从100 mA减小到1 mA时,过冲电压被限制在550 mV以内,稳定时间小于50μs.由于采用了30 nA的电流基准,本设计的静态功耗仅为3.3μA.通过CSMC公司0.5 μm CMOS工艺进行设计并流片验证,芯片测试结果与仿真结果吻合. 相似文献