Fabrication of rigid microstructures with thiol-ene-based soft lithography for continuous-flow cell lysis |
| |
| Authors: | Jeffrey M Burke Kunal R Pandit John P Goertz Ian M White |
| |
| Institution: | 1.Fischell Department of Bioengineering, University of Maryland, College Park, Maryland 20742, USA;2.Department of Chemical and Biomolecular Engineering, University of Maryland, College Park, Maryland 20742, USA |
| |
| Abstract: | In this work, we introduce a method for the soft-lithography-based fabrication of rigid microstructures and a new, simple bonding technique for use as a continuous-flow cell lysis device. While on-chip cell lysis techniques have been reported previously, these techniques generally require a long on-chip residence time, and thus cannot be performed in a rapid, continuous-flow manner. Microstructured microfluidic devices can perform mechanical lysis of cells, enabling continuous-flow lysis; however, rigid silicon-based devices require complex and expensive fabrication of each device, while polydimethylsiloxane (PMDS), the most common material used for soft lithography fabrication, is not rigid and expands under the pressures required, resulting in poor lysis performance. Here, we demonstrate the fabrication of microfluidic microstructures from off-stoichiometry thiol-ene (OSTE) polymer using soft-lithography replica molding combined with a post-assembly cure for easy bonding. With finite element simulations, we show that the rigid microstructures generate an energy dissipation rate of nearly 107, which is sufficient for continuous-flow cell lysis. Correspondingly, with the OSTE device we achieve lysis of highly deformable MDA-MB-231 breast cancer cells at a rate of 85%, while a comparable PDMS device leads to a lysis rate of only 40%. |
| |
| Keywords: | |
|
|
