| 低温环境下不同预热温度对T形接头焊接结果的分析 |
| |
| 引用本文： | 张建.低温环境下不同预热温度对T形接头焊接结果的分析[J].温州职业技术学院学报,2014(1):61-64. |
| |
| 作者姓名： | 张建 |
| |
| 作者单位： | 毕节市工业学校,贵州毕节551700 |
| |
| 摘 要： | 低温环境金属的焊接易导致焊接接头产生冷裂纹.为减少焊接冷裂纹的产生,需采用预热措施.采用焊条电弧焊在环境温度为-15℃下进行T形接头焊接仿真,运用Simufact-Welding软件分析焊件预热到80℃和120℃时焊缝处的残余变形和残余应力.结果表明,预热到120℃时,焊缝处的残余变形小;预热到120℃时,除焊缝起始点和终止点外,其余焊缝处的残余应力小.因此,合理控制预热温度,可减小晶粒脆化;适当增大t./5时间,有利于缓解接头的冷却速度,减小淬硬倾向.
|
| 关 键 词： | 低温环境 预热温度 焊条电弧焊 T形接头 |
An Analysis on the Effect of Different Preheating Temperature on T-shaped Downhand Weld under Low Temperature |
| |
| ZHANG Jian.An Analysis on the Effect of Different Preheating Temperature on T-shaped Downhand Weld under Low Temperature[J].Journal of Wenzhou Vocational & Technical College,2014(1):61-64. |
| |
| Authors: | ZHANG Jian |
| |
| Institution: | ZHANG Jian (Bijie Polytechnic School, Bijie, 551700, China) |
| |
| Abstract: | Welding in the low temperature will cause weld cracks in the welding joint. To prevent the weld crack, measures should be taken in preheating. Welding the T-shaped joint under the temperature of -15 ℃ by using the arc welding, an analysis is made on the residual deformation and residual stress at welded seams by applying Simufact-Welding software when the weldment preheats to 80℃ 120℃. It is showed that when preheating to 120℃, the residual deformation at welded seams is small, and except the starting point and the ending point of welded seams, the residual stress at other welded seams is small. Therefore, controlling the preheating temperature can decrease the embrittlement of grain, enlarge t8/5 time, relieve the cooling speed of the joint and lessen the hardening. |
| |
| Keywords: | Low Temperature Preheating temperature Arc welding T-shaped joint |
| 本文献已被 CNKI 维普 等数据库收录！ |
|
