| 简析形位公差选择的合理性 |
| |
| 引用本文： | 李国富.简析形位公差选择的合理性[J].鄂州大学学报,2007,14(2):35-37. |
| |
| 作者姓名： | 李国富 |
| |
| 作者单位： | 鄂州大学机械系,湖北,鄂州,436000 |
| |
| 摘 要： | 针对形位公差项目选择中存在的一些问题,用简明的图示对比,该文阐述了形位公差之间的关系,论述了形位公差的选用原则,分析了合理选择各种形位公差的原理及方法。
|
| 关 键 词： | 形位公差 被测要素 选用原则 |
| 文章编号： | 1008-9004（2007）02-0035-03 |
| 修稿时间： | 2007-01-06 |
Brief analysis of how to reasonably select shape and position tolerances |
| |
| LI Guo-fu.Brief analysis of how to reasonably select shape and position tolerances[J].Journal of Ezhou University,2007,14(2):35-37. |
| |
| Authors: | LI Guo-fu |
| |
| Institution: | Department of Mechanical Engineering, Ezhou University, Ezhou, Hubei 436000, China |
| |
| Abstract: | Relation between shape and position tolerances and principle for selection of shape and position tolerances are expounded in this paper by brief graph comparison regarding some problems encountered in selection of shape and position tolerance items.How to reasonably select shape and position tolerances and why are also discussed in this paper. |
| |
| Keywords: | shape and position tolerance tested element principle of selection |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
