| 加工中硬齿轮用滚刀的设计修形 |
| |
| 引用本文： | 王彦红,白玲.加工中硬齿轮用滚刀的设计修形[J].焦作大学学报,2003,17(2):73-74. |
| |
| 作者姓名： | 王彦红 白玲 |
| |
| 作者单位： | 1. 焦作华飞电子电器工业有限公司,河南,焦作,454100
2. 焦作市液压机械厂,河南,焦作,454000 |
| |
| 摘 要： | 分析了滚齿齿轮齿形误差的来源，并根据计算结果和有关资料给出了滚切中硬齿面齿轮用滚刀的修形量。分析和试验表明，滚刀中凹修形可有效地控制中硬齿轮齿形误差的数值和方向，能保证齿轮副接触带的位置和宽度，符合设计与使用要求。
|
| 关 键 词： | 滚齿齿轮 滚切 中硬齿轮 滚刀 设计 修形量 齿形误差 中凹修形 |
| 文章编号： | 1008-7257(2003)02-0073-02 |
| 修稿时间： | 2002年11月11 |
The Revised Design of Machining the Hobbing Cutter for the Medium-Hard Gear |
| |
| WANG Yan-hong,BAI Ling.The Revised Design of Machining the Hobbing Cutter for the Medium-Hard Gear[J].Journal of Jiaozuo University,2003,17(2):73-74. |
| |
| Authors: | WANG Yan-hong BAI Ling |
| |
| Abstract: | This paper analyses the source of the hobbing gear error and provides the revised quantity of the hobbing cutter for the medium_hard gear according to calculation result and materials concerned. The analysis and experiments suggest that the revised design of the medium_and_concave hobbing cutter effectively controls the digital ratio and the direction of the medium_and_hard gear errors, guarantees the position and width of the auxiliary contact zone of gears and meets the requirement of design and utilization. |
| |
| Keywords: | medium_and_hard gear hobbing cutter revised design |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
