| 基于ANSYS Workbench的数控插齿机主轴分析 |
| |
| 引用本文： | 杨世成,王海文,郭卫.基于ANSYS Workbench的数控插齿机主轴分析[J].张家口职业技术学院学报,2011,24(2):52-54. |
| |
| 作者姓名： | 杨世成 王海文 郭卫 |
| |
| 作者单位： | 1. 张家口职业技术学院,河北张家口,075051
2. 西安科技大学,陕西西安,710054 |
| |
| 摘 要： | 采用ANSYY Workbench对数控插齿机主轴进行有限元分析。在软件DM中建立主轴模型,利用软件的自动划分网格技术划分网格,并施加载荷和约束、求解;利用输出的主轴的正应力曲线、主轴总变形和主轴在Y方向的变形曲线对主轴性能进行分析。
|
| 关 键 词： | ANSYS 插齿机 主轴 |
Spindle Analysis of Numerical Control Gear Slotting Machine Based on ANSYS Workbench |
| |
| YANG SHI-cheng,WANG HAI-wen,GUO Wei.Spindle Analysis of Numerical Control Gear Slotting Machine Based on ANSYS Workbench[J].Journal of Zhangjiakou Vocational College of Technology,2011,24(2):52-54. |
| |
| Authors: | YANG SHI-cheng WANG HAI-wen GUO Wei |
| |
| Institution: | YANG SHI-cheng1,WANG HAI-wen2,GUO Wei2(1.Zhangjiakou Vocational and Technical College,Zhangjiakou,Hebei 075000,2.Xi'An University of Science and Technology,Xi'An,Shanxi 710054) |
| |
| Abstract: | Spindle of Numerical Control gear slotting machine,is analyzed by ANSYS Workbench.Spindle model is created in DM of the software,mesh are generated through using automatic mesh partition techniques of software on spindle.Loads and restraint forces are applied on the spindle FEM model.The spindle total deformation curve,the spindle Y directional deformation curve,and the spindle normal stress curve are obtained.It analyzes the spindle performance to use these simulation curves. |
| |
| Keywords: | ANSYS gear slotting machine spindle |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
|
