Erratum to: Can a rat count?     

Hiroshi Imada  Hiroyasu Shuku  Mitsuyo Moriya 《Learning & behavior》1984,12(2):248-248

  相似文献   

Sequential muscle activity and its functional role in the upper extremity and trunk during overarm throwing   总被引：1，自引：1，他引：0  

Hirashima M  Kadota H  Sakurai S  Kudo K  Ohtsuki T 《Journal of sports sciences》2002,20(4):301-310

The proximal-to-distal segmental sequence has been identified in many sports activities, including baseball pitching and ball kicking. However, proximal-to-distal sequential muscle activity has not been identified. The aims of this study were to establish whether sequential muscle activity does occur and, if it does, to determine its functional role. We recorded surface electromyograms (EMGs) for 17 muscles from the upper extremity and abdomen during overarm throwing and detected the onset and peak times as indices of muscle activity. The following electromyographic properties were commonly identified in the participants. First, sequential muscle activity was observed from the scapular protractors to the shoulder horizontal flexors and from the shoulder horizontal flexors to the elbow extensor, but not from the elbow extensor to the wrist flexor or forearm pronator. Secondly, the external oblique contralateral to the throwing arm became activated before the ipsilateral external oblique. This sequence is considered to be very effective for the generation of high force and energy in the trunk. Thirdly, the ipsilateral external oblique began its activity almost at foot strike. Finally, the main activity of the rectus abdominis appeared just before the point of release.  相似文献   

Consensus of linear multi-agent systems based on full-order observer     

Zixi Li  Hiroshi Ishiguro 《Journal of The Franklin Institute》2014

This paper considers distributed consensus problem of multi-agent systems consisting of general linear dynamics with a time-invariant communication topology. A distributed full-order observer type consensus protocol based on relative output measurements of neighbor agents is proposed. It is found that the consensus problem of linear multi-agent systems with a directed communication topology having a spanning tree can be solved if and only if all subsystems are asymptotically stable. Some necessary and sufficient conditions are obtained for ensuring consensus in multi-agent systems. The design technique is based on algebraic graph theory, Riccati inequality and linear control theory. Finally, simulation example is given to illustrate the effectiveness of the theoretical results.  相似文献   

Automatic extraction of bilingual word pairs using inductive chain learning in various languages     

Hiroshi Echizen-ya  Kenji Araki  Yoshio Momouchi 《Information processing & management》2006

In this paper, we propose a new learning method for extracting bilingual word pairs from parallel corpora in various languages. In cross-language information retrieval, the system must deal with various languages. Therefore, automatic extraction of bilingual word pairs from parallel corpora with various languages is important. However, previous works based on statistical methods are insufficient because of the sparse data problem. Our learning method automatically acquires rules, which are effective to solve the sparse data problem, only from parallel corpora without any prior preparation of a bilingual resource (e.g., a bilingual dictionary, a machine translation system). We call this learning method Inductive Chain Learning (ICL). Moreover, the system using ICL can extract bilingual word pairs even from bilingual sentence pairs for which the grammatical structures of the source language differ from the grammatical structures of the target language because the acquired rules have the information to cope with the different word orders of source language and target language in local parts of bilingual sentence pairs. Evaluation experiments demonstrated that the recalls of systems based on several statistical approaches were improved through the use of ICL.  相似文献   

An integrated teaching method of gross anatomy and computed tomography radiology          下载免费PDF全文

Tohru Murakami  Yuki Tajika  Hitoshi Ueno  Sachiko Awata  Satoshi Hirasawa  Maki Sugimoto  Yoshihiko Kominato  Yoshito Tsushima  Keigo Endo  Hiroshi Yorifuji 《Anatomical sciences education》2014,7(6):438-449

It is essential for medical students to learn and comprehend human anatomy in three dimensions (3D). With this in mind, a new system was designed in order to integrate anatomical dissections with diagnostic computed tomography (CT) radiology. Cadavers were scanned by CT scanners, and students then consulted the postmortem CT images during cadaver dissection to gain a better understanding of 3D human anatomy and diagnostic radiology. Students used handheld digital imaging and communications in medicine viewers at the bench‐side (OsiriX on iPod touch or iPad), which enabled “pixel‐to‐tissue” direct comparisons of CT images and cadavers. Students had lectures and workshops on diagnostic radiology, and they completed study assignments where they discussed findings in the anatomy laboratory compared with CT radiology findings. This teaching method for gross and radiological anatomy was used beginning in 2009, and it yielded strongly positive student perspectives and significant improvements in radiology skills in later clinical courses. Anat Sci Educ 7: 438–449. © 2014 American Association of Anatomists.  相似文献   

An integrated microfluidic device for rapid serodiagnosis of amebiasis     

Wang Zhao  Li Zhang  Wenwen Jing  Sixiu Liu  Hiroshi Tachibana  Xunjia Cheng  Guodong Sui 《Biomicrofluidics》2013,7(1)

A microfluidic device was successfully fabricated for the rapid serodiagnosis of amebiasis. A micro bead-based immunoassay was fabricated within integrated microfluidic chip to detect the antibody to Entamoeba histolytica in serum samples. In this assay, a recombinant fragment of C terminus of intermediate subunit of galactose and N-acetyl-_D-galactosamine-inhibitable lectin of Entamoeba histolytica (C-Igl, aa 603-1088) has been utilized instead of the crude antigen. This device was validated with serum samples from patients with amebiasis and showed great sensitivity. The serodiagnosis can be completed within 20 min with 2 μl sample consumption. The device can be applied for the rapid and cheap diagnosis of other infectious disease, especially for the developing countries with very limited medical facilities.Entamoeba histolytica is the causative agent of amebiasis and is globally considered a leading parasitic cause of human mortality.¹ It has been estimated that 50 × 10⁶ people develop invasive disease such as amebic dysentery and amebic liver abscess, resulting in 100 000 deaths per annum.^{2, 3} High sensitive diagnosis method for early stage amebiasis is quite critical to prevent and cure this disease. To date, various serological tests have been used for the immune diagnosis of amebiasis, such as the indirect fluorescent antibody test (IFA) and enzyme-linked immunosorbent assay (ELISA).We have recently identified a 150-kDa surface antigen of E. histolytica as an intermediate subunit (Igl) of galactose and N-acetyl-_D-galactosamine-inhibitable lectin.^{4, 5} In particular, it has been shown that the C-terminus of Igl (C-Igl, aa 603-1088) was an especially useful antigen for the serodiagnosis of amebiasis. ELISA using C-Igl is more specific than the traditional ELISA using crude antigen.⁶ However, the ELISA process usually takes several hours, which is still labor-intensive and requires experienced operators to perform. More economic and convenient filed diagnosis methods are still in need, especially for the developing countries with limited medical facilities.Among all the bioanalytical techniques, microfluidics has been attracting more and more attention because of its low reagent/power consumption, the rapid analysis speed as well as easy automation.^{7, 8, 9, 10, 11} Especially with the development of the fabrication technique, microfluidics chip can include valves, mixers, pumps, heating devices, and even micro sensors, so many traditional bioanalytical methods can be performed in the microfluidics. Qualitative and quantitative immune analysis on the microfluidic chip was successfully proved by plenty of research with improved sensitivity, shorten reaction time, and less sample consumption.^{8, 10, 11, 12, 13, 14, 15, 16, 17} Moreover, with the intervention of other physical, chemical, biology, and electronic technology, microfluidic technique has been successfully utilized in protein crystallization, protein and gene analysis, cell capture and culturing and analysis as well as in the rapid and quantitative detection of microbes.^{13, 14, 15, 16, 17, 18, 19, 20}Herein, we report a new integrated microfluidic device, which is capable of rapid serodiagnosis of amebiasis with little sample consumption. The microfluidic device was fabricated from polydimethysiloxane (PDMS) following standard soft lithography.^{21, 22} The device was composed of two layers (shown in Figure ​Figure1)1) including upper fluidic layer (in green and blue) and bottom control layer (in red).Open in a separate windowFigure 1Structure illustration of microfluidic chip.To create the fluidic layer and the control layer, two different molds with different patterns have fabricated by photolithographic processes. The mold to create the fluidic channels was made by positive photoresist (AZ-50 XT), while the control pneumatic mold was made by negative photoresist (SU8 2025). For the chip fabrication, the fluidic layer is made from PDMS (RTV 615 A: B in ratio 5:1), and the pattern was transferred from the respective mold. The control layer is made from PDMS (RTV 615 A:B in ratio 20:1). The two layers were assembled and bonded together accurately, and there is elastic PDMS membrane about 30 μm thick between the fluidic layer channels and control layer.^{21, 22} The elastic membrane at the intersection can deform to block the fluid inside the fluidic channels, functioning as valves under the pressures introduced though control channels. There are two types of channels in fluidic layer, the rectangular profiled (in green, 200 μm wide, 35 μm thick) channel and round profiled channels (in blue, 200 μm wide, 25 μm center height). Because of the position of the valves on the fluidic channels, two types of valves (Figure ​(Figure2a)2a) were built, working as a standard valve and a sieve valve. The standard valves (on blue fluidic channels) can totally block the fluid because of the round profile of fluidic channel; the sieve valve can only half close because of the rectangular profile. The sieve valve can be used to trap the microspheres (beads) filled inside the green fluidic channels, while letting the fluid pass through. By this sieve valve, a micro column (in green) is constructed, where the entire ELISA reaction happens. The micrograph of the fabricated micro device is shown in Figure ​Figure2b.2b. The channels were filled with food dyes in different colors to show the relative positions of the channels. The pressures though different control channels are individually controlled by solenoid valves, connected to a computer through relay board. By programming the status (on/off) of various valves at different time periods, all the microfluidic chip operation can be digitally controlled by the computer in manual, semi-automatic, or automatic manner.Open in a separate windowFigure 2(a) Structure illustration of micro column, standard valve and sieve valve; (b) photograph of the microfluidic chip.To validate this device, 12 patient serum samples were collected. Sera from 9 patients (Nos. 1–9) with an amebic liver abscess or amebic colitis were used as symptomatic cases. The diagnosis of these patients was based on their clinical symptoms, ultrasound examination (liver abscess) and endoscopic or microscopic examination (colitis). We also identified the clinical samples using PCR amplification of rRNA genes.²⁴ As negative control, sera obtained from 3 healthy individuals with no known history of amebiasis were mixed into pool sera. The serum was positive for E. histolytica with a titer of 1:64 (borderline positive), as determined by an indirect fluorescent-antibody (IFA) test.^{23, 24} In our previously study, the sensitivity and specificity of the recombinant C-Igl in the ELISA were 97% and 99%.^{6, 25} In the current study, the serodiagnosis of amebiasis was also examined by ELISA using C-Igl.²⁶ The cut-off for a positive result was defined as an ELISA value > 3 SD above the mean for healthy negative controls²⁷ (shown in Figure ​Figure3).3). The seropositivity to C-Igl was 100% in patients with amebiasis.Open in a separate windowFigure 3ELISA reactivity of sera from patients against C-Igl. ELISA plate was coated with 100 ng per well of C-Igl. Serum samples from patients and healthy controls were used at 1:400 dilutions. The dashed line indicates the cut-off value. Data are representative of results from three independent experiments.In the diagnosis process with microfluidic chip, the 4 micro immuno-columns filled with C-Igl-coated microspheres were the key components of the device. The C-Igl was prepared in E. coli as inclusion bodies. After expression, the recombinant protein was purified and analyzed by SDS-PAGE. The apparent molecular mass was 85 kDa.²⁶The immune-reaction mechanism is illustrated in Figure ​Figure4.4. The anti-His monocolonal antibody was immobilized onto the microspheres (beads, 9 μm diameter) coated with protein A. The C-Igl was then immobilized onto the beads through the binding between the His tag and C-Igl. For the diagnosis, the microspheres immobilized with C-Igl and blocked by 5% BSA were preloaded into the columns for the rapid analysis of the patient serum samples. Generally, serum samples which were diluted 100 times were first loaded into the reaction column and incubated at room temperature for 5 min. After being washed by PBS buffer, FITC-conjugated goat anti-human polyclonal antibody was added into the column for 4 min incubation. The fluorescence image can be collected by the fluorescence microscope after the micro column was washed with PBS buffer. From loading diluted serum samples into column to collecting fluorescence images, the total time to complete the immunoassay is less than 10 min. The final fluorescence results were analyzed by Image Pro Plus 6.0.Open in a separate windowFigure 4Schematic representation of the ELISA in the chip.Different reaction conditions have been investigated to find the optimized ones. For each patient, 2 μl sample is enough for the analysis. The designed microfluidic chip with 4 micro columns is capable for 4 parallel analyses at the same time. More micro columns can be integrated into the device if more parallel tests are needed.Different incubating time for the diagnosis has also been investigated and no significant difference has been found for various time periods. It is enough to incubate the chip for only 5 min. The total diagnosis time for one sample is less than 10 min. The detection result appeared as the fluorescence intensity of the reaction column. As shown in Figure ​Figure5,5, the negative sample showed relatively low fluorescence intensity, because little FITC-conjugated goat anti-human polyclonal antibody could attach to the surface of microspheres; on the contrast, the positive sample showed much brighter fluorescence. The fluorescence intensity can be transferred to digital data (Table